Menu

Tabriz Tile

Advises

Before starting the installation of tiles and ceramics you should do the following :

First, check that the product you purchased is suitable for your space according to the technical information.

Check that the product is purchased as needed.

Check the cartons for the product to be of one size, shape and caliber.

The most important thing about a good ceramic performance is its proper installation and the following is a very important issue.

1 – Location

Installation should be tight, free of debris and dirt. Installation time should not be too cold or too hot.

Installation should be smooth, firm and uniform, if necessary, prior to product installation.

All conditions include floor and wall mounting.

2 – Material

To make the effects look more beautiful and display better, the pieces should be randomly removed from the cartons and executed. If your product has different shades and graphics, it should be randomly installed.

3 – Tile intersection

For better installation of ceramics you should use cross straps. Cross straps are used for a more beautiful installation, observance of important technical issues, alignment of materials, absorption of any deformation on the wall and floor surfaces. Finally, it prevents the deformation of the ceramic components.

Minimal use of the suggested cross straps will help make your ceramic installation easier and more beautiful. So, to avoid any mistake, follow all the rules and regulations:

Cut products : At least 1 mm
Non-cut products : At least 1 mm
Rubric products : 1 – 2 mm

Note : Regardless of the amount written, the installer must observe installation laws in each country.

4 – Adhesive and Mortar

Mortars, filler mortars, cement adhesives and other adhesives should have the ability to adhere to the type of ceramic or ceramic installation site – exterior, floor – wall, flat – non-planar surfaces.

You must follow the manufacturer’s instructions when installing and using.

5 – Cutting

You can use a hand cutter to cut ceramic pieces.

To cut harder parts, you can use an electric cutter with water to cool the machine to more than one horsepower.

6 – Punching

You need to use a diamond drill to fit the hole you are looking for.

7 – Safety and Preparation of Materials

We recommend that you use personal protective equipment.

Wear safety shoes, gloves, safety goggles, and ear guards when cutting products.

You have to choose the right method for moving and moving parts.

8 – Maintenance and Cleaning

Immediately after the installation of ceramics, it is recommended that the ceramics be well protected.

It is recommended to use a buffer and a cleaner to clean the remaining soil, cement, cross straps, etc.

You must use neutral detergent for daily washing.

When cleaning decorative parts, avoid using abrasive detergents that can damage them.

Third baking pieces with different lead, gold, silver, etc. coatings should be carefully cleaned.

For the final cleaning and maintenance of this product, a suitable neutral detergent should be used to create an anti-static effect that can repel soil and protect the product from corrosion.

9 – Packaging Waste Management

Waste generated (cardboard and plastic) should be segregated in suitable locations for recycling.


Designed by TabrizTileGroup's IT Department